Location
2333 Rusmar St
Cape Girardeau, MO 64801
Cost
$3,046
Includes Lunch Each Day
Date & Time
Tue, Aug 20 - Fri, Aug 23
08:00 AM - 05:00 PM
About this event
After completing this course, you should be able to configure, test, tune, and program CIP motion axes in the Studio 5000 Logix Designer® programming environment.

Please register before July 24, 2024.
Prerequisites
To successfully complete this course, the following prerequisites are required: - A background in basic electricity, electronics, and computer concepts • A basic knowledge of controllers operation
Register Today
Speakers & Coordinators
Featured Speakers
Guest Speaker
Guest Speaker
Rockwell Automation
SMC Coordinators
Aislinn Roberts
aroberts@smcelectric.com | 573.334.2861
Course Agenda
  • Day 1
    • Configuring a Studio 5000 Logix Designer project for integrated motion over an EtherNet/IP network
    • Adding and configuring EtherNet/IP drives and configuring CIP servo axes 
    • Testing hardware for integrated motion over an EtherNet/IP network 
    • Tuning axes over an EtherNet/IP network 
    • Applying programming best practices for integrated Motion applications over an EtherNet/IP network
  • Day 2
    • Programming instructions to turn on and turn off Servo control 
    • Programming instructions to hone and stop axes 
    • Programming instructions to move and jog axes 
    • Programming shutdown and recovery instructions
  • Day 3
    • Integrated Practice: creating a basic integrated motion application controlled over an EtherNet/IP network 
    • Programming group motion instructions
    • Dynamically altering move parameters 
    • Adding a virtual axis
  • Day 4
    • Programming gearing instructions 
    • Programming position camming instructions 
    • Programming time camming instructions
    • Integrated Practice: programming dependent motion instructions for an integrated motion application controlled over an EtherNet/IP network


SMC Training Event Enrollment and Cancellation Policy
Enrollment Policy
SMC Training Event registrations will close 7 calendar days prior to the class start time and date. No exceptions will be granted.
Cancellation Policy
If a Training Event enrollment is canceled more than 14 days before the scheduled start of the event, 100% of the tuition will be refunded. If an enrollment is cancelled 13 days or closer to the start of the Training Event, full tuition will be charged. If a student fails to appear for a scheduled course, full tuition will be charged. Training Event Refunds will be completed within 60 days of cancellation date.
To cancel or reschedule your enrollment in a Training Event, contact your SMC Enrollment Specialist.
SMC strongly suggests that students only make refundable travel and lodging arrangements.
SMC reserves the right to alter course schedules, content, limit class size, reschedule, discontinue, or cancel courses. If a course is canceled by SMC, tuition will be refunded in full, however, SMC cannot be held liable for any other expenses incurred by delegates of their organization due to cancellation.