Location
585 N Washington Ave
Springfield, Missouri 65806
Cost
$900
Includes Lunch
Date & Time
Wed, Mar 12 - Wed, Mar 12
08:00 AM - 04:00 PM
About this event

This course will cover start-up, parameter setting and troubleshooting of PowerFlex 750-Series VFD’s using the HIM interface and using Connected Components Workbench software.


Please register before February 26, 2025.
Prerequisites
To successfully complete this course, the following prerequisites are required: - -
Register Today
Speakers & Coordinators
Featured Speakers
Mark Lindsey
Mark Lindsey
SMC Automation Specialist
SMC Coordinators
Tyler Perry
tperry@smcelectric.com | 417.865.2825
Course Agenda
    • Basic troubleshooting
    • Hands-on labs
    • Navigating parameters 
    • Drive set up (analog and digital) 
    • Ethernet control 
    • Basic fault and alarm codes 



SMC Training Event Enrollment and Cancellation Policy
Enrollment Policy
SMC Training Event registrations will close 7 calendar days prior to the class start time and date. No exceptions will be granted.
Cancellation Policy
If a Training Event enrollment is canceled more than 14 days before the scheduled start of the event, 100% of the tuition will be refunded. If an enrollment is cancelled 13 days or closer to the start of the Training Event, full tuition will be charged. If a student fails to appear for a scheduled course, full tuition will be charged. Training Event Refunds will be completed within 60 days of cancellation date.
To cancel or reschedule your enrollment in a Training Event, contact your SMC Enrollment Specialist.
SMC strongly suggests that students only make refundable travel and lodging arrangements.
SMC reserves the right to alter course schedules, content, limit class size, reschedule, discontinue, or cancel courses. If a course is canceled by SMC, tuition will be refunded in full, however, SMC cannot be held liable for any other expenses incurred by delegates of their organization due to cancellation.